Easily remove your 2010 Ford Focus door panel yourself with this simple step-by-step process from AFA Tooling Approved for Automotive. With just one set of t Although the bulb version fits the same way as the LED outer unit, I can't say if it's the same for the inner. So what I did was; 1) Removed the centre trim panel at the top of the rearwindscreen. It's just clip studs into the body panel and a couple of plastic ones into the adjacent white panels. Bulb Required 12V 21/5W.Just two screws to remove,Twist the Light Unit Off carefully so as not to damage the cables.Optionally disconnect cable by pressing t Bryleigh. Remove the passenger wing mirror, 3 x 8mm headed bolts. Remove the interior trim piece, un plug the mirror from the harness. At the bottom of the mirror you will see the ambient temp sensor. Remove this and peel back the fabric tape. Cut the wires and replace with new sensor (£9.99 ebay) and solder in place. Video on how to replace / change / install new front fog light bulbs on Ford Focus sedan ( 2011 | 2012 | 2013 | 2014 | 2015 | 2016 | 2017 | 2018 | S | SE | S I this video, I'll be upgrading the interior light of my MK2 facelift Focus. replacing the main light with an upgraded titanium one, footwell lights, and extra boot light and all bulbs TfNB. 5976 posts · Joined 2013. #7 · Aug 18, 2014. According to my Haynes manual it is held in by a screw in each top corner and then lifts out. You need to disconnect the wiring and cables from the back, taking note of the cable positions. In true tradition refitting is, of course, the reverse of the procedure! I`ve had leaks through ceilings at home so instinctively looked up and sure enough there was drops of water coming out by the side of the interior light fitting. Closer inspection revealed that the front of the roof lining (where it abuts the windscreen) was wet along its entire length, there was water all over the front of the stereo, and some How do you change the tailgate on a Ford Focus. This video will show you how to install a new one. The replacement of the trunk / boot lid on a Ford Focus. today I finished installing the ambient lighting in my 2007 ford focus mk2 st2, now some have seen the first video and asked for a full install video or a "H This is achieved by inserting the screwdriver *at an angle* thus: It takes a little practice, but with a little care it can be done quickly. Once the assembly has been released, twist the bulb holder to remove it from the lens assembly and replace the bulb. Put it all back together and clip back in place. remove the trim panel btwn the A pillar and the kick panel (pull out from the bottom, then down) remove the B pillar trim panel (pull outwards toward the front of the car near the plastic clip on the bottom), this will pop the clip out. remove that and then pull straight to the center of the car. when putting this back be careful to align the

ford focus mk2 interior light removal